Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

asa 5510 ips module

I have run setup and given the ips an address that is consistent with the inside network. I reset but cannot ping the address either from an inside switch or from the asa. What am I doing wrong?

3 REPLIES
Silver

Re: asa 5510 ips module

Make sure the subnet mask is also set right. This is where sometime we miss out. If everything is right reset and reconfigure the device once. Try adding a static ARP entry for the ip address of the device. In windiws command to enter a static ARP

arp -s . If nothing works upgrade the software.

New Member

Re: asa 5510 ips module

Hi,

I have the same situation. HOw did you reslove this issue?

Bronze

Re: asa 5510 ips module

The IP-address on the IPS-module is for management-purpose only, so you need to patch the ethernet interface on the outside of the module to you internal network. Also you need to make sure the IP-address is in the same subnet as the internal network!

Please rate if the post is usefull!

Regards,

Michael

253
Views
0
Helpful
3
Replies