ASA 5510 L2L Dynamic IP and ASDM

[Json12345]

Hello.

I'm looking for a ASDM guide to implement L2L tunnel between a ASA 5510 with static ip and a device with a dynamic ip. I relly suck when it comes to CLI so I would like some help setting this up via ASDM. I've got it working once but that was a long time ago so i don't remember the way of doing this. I think it all went bad when I added a Remote Access VPN for a client.

[andrew.prince]

Below are the config examples for PIX/ASA:-

http://www.cisco.com/en/US/products/ps6120/prod_configuration_examples_list.html

HTH>

[Json12345]

Follow up.

I'm getting theese errors:

Group = DefaultRAGroup, IP = x.x.x.x, Removing peer from peer table failed, no match!

[andrew.prince]

That is because you have not configured a dynamic CRYPTO group for remote VPNs - check your config.

HTH>

[Json12345]

yes, it was the Linksys router with the dynamic ip that only could authanticate with ip and not name.

It's working now with a different router.

[andrew.prince]

np - glad to help.