I could.nt find where this would appear in the CLI, but on our ASA 5520's ASDM console if I go to Monitoring > VPN Statistsics > Sessions > Filter by Site-to-Site > Select a VPN and choose details > within details there is a ACL tab.
Mine says "ACLs are not being applied to this session"
Think is I have "no sysopt connection permit-vpn" on my config so I have had to create many ACE's within the default ACL's. So should I be worried?
Thing is I know ACL's/ACE's are in use because if I disable them then the traffic stops flowing over the VPN.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...