I am trying to set up a VPN tunnel between a PIX 501 and an ASA 5540. The ASA has a static outside interface, but the Pix outside interface will be assigned by DHCP. So, I cannot use a "Peer" statement in the ASA, since this could change. I have the VPN config done on the Pix end, but need to know how to configure the ASA to accept a VPN tunnel connection from a dynamic ip address. Any help will be greatly appreciated.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...