01-28-2010 09:32 AM - edited 02-21-2020 04:28 PM
I am going to use an ASA-5540 as our VPN head-end termination device only - and not as a firewall.
Also, we have a routeable class-B address for our internal enterprise address space, so we have no need to NAT. I'd like to turn off the NAT 0 function if I can so I don't have to always add to the NAT 0 just to make sure that the 5540 does not NAT.
Is there any easy way to disable the need use NAT 0?
Are there any draw backs to doing that?
Solved! Go to Solution.
02-04-2010 01:32 PM
You can disable the use of nat 0 by disabling nat-control.
To get this done, go to global config mode and use this command:
no nat-control
To check if you have it enabled or not, you can check it with:
sh run nat-control
Cheers!
- Yamil
02-04-2010 01:32 PM
You can disable the use of nat 0 by disabling nat-control.
To get this done, go to global config mode and use this command:
no nat-control
To check if you have it enabled or not, you can check it with:
sh run nat-control
Cheers!
- Yamil
02-04-2010 01:32 PM
You can disable the use of nat 0 by disabling nat-control.
To get this done, go to global config mode and use this command:
no nat-control
To check if you have it enabled or not, you can check it with:
sh run nat-control
Cheers!
- Yamil
02-04-2010 01:32 PM
You can disable the use of nat 0 by disabling nat-control.
To get this done, go to global config mode and use this command:
no nat-control
To check if you have it enabled or not, you can check it with:
sh run nat-control
Cheers!
- Yamil
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide