Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

ASA 55xx con Fortinet ????

estoy generando una vpn L2L con mi cisco ASA 5520 , y un Fortinet ,........es posible, se puede, help??????

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hi Rdelgado, Yes we can have

Hi Rdelgado,

 

Yes we can have site to site VPN between ASA and Fortigate firewall. Please refer to this document:

http://docs-legacy.fortinet.com/cb/recipes/configuring-IPsec-VPN-with-a-FortiGate-and-a-Cisco-ASA.pdf

 

Vishnu

7 REPLIES

HI, Dear, its not face-book,

HI,

 

Dear, its not face-book, plz write in full form and pure English only

 

Regards,

syed

skmkazim552:    IP=x.x.x.x

skmkazim552:

 

   IP=x.x.x.x,Error processing payload:Payload ID:1

plz check herehttps:/

plz check here

https://supportforums.cisco.com/discussion/11234946/cisco-asa-vpn-error-processing-payload-payload-id-1

 

 

HTH

"please rate for helpful posts"

Cisco Employee

Hi Rdelgado, Yes we can have

Hi Rdelgado,

 

Yes we can have site to site VPN between ASA and Fortigate firewall. Please refer to this document:

http://docs-legacy.fortinet.com/cb/recipes/configuring-IPsec-VPN-with-a-FortiGate-and-a-Cisco-ASA.pdf

 

Vishnu

 vishnsha,     me arroja este

 vishnsha,

 

    me arroja este mensaje en los log de mi ASA;

 

   IP=x.x.x.x,Error processing payload:Payload ID:1

Cisco Employee

Podría por favor compartir la

Podría por favor compartir la depuración completa. También me envía la salida de los comandos siguientes:

 

debug crypto isa 127 (if using 8.2 version) / debug crypto ikev1 127 (if using 8.4 and later version)
debug cry ipsec 127

 

 

Vishnu

  Vishnu, en la salida de

  Vishnu, en la salida de este comando;

   debug crypto isa 127,   

    no veo llegando la IP del peer Fortinet, solo veo IPs de otros clientes.

 

   en la salida de este comando, tampoco veo la IP:

   debug crypto isa 200  ,  arroja lo mismo.

 

   

78
Views
0
Helpful
7
Replies
CreatePlease to create content