ASA and AnyConnect - Automatically Select Best Server
If I have two servers in different regions, is it possible to have the AnyConnect client connect to the server it has the least latency too?
I'm sure I have seen a reference to this before but I am struggling to find any documentation on it. For example, I have an ASA in Europe and another ASA in North America. I would like for the AnyConnect client to automatically determine which server it has the smallest response time too and use that to connect too.
I would appreciate if someone can point me in the right direction.
No such features is available in any connect , which can determine automatically the head server based on Latency response , You can define only Back up server , in case your primary head end fails , it initiates connection to secondary head end server
You can configure a list of backup servers the client uses in case the user-selected server fails. These servers are specified in the AnyConnect client profile, in the ClientInitialization section. In some cases, the BackupServerList might specify host specific overrides.
These parameters do not have default values; that is, if you do not specify a parameter, it is simply not in effect. Table 3-16 lists these parameters and defines their possible values.
Note Include the BackupServerList section in a profile only if you want to specify backup servers.
Table 3-16 Backup Server Parameters
An IP address or a
Domain Name (FQDN)
Specifies a host address to include in the backup server list.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...