Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ASA failover question

I have read all the docs regarding ASA failover using the sla monitor command. The doc indicates that the failover occurs between two interfaces (eth0/0 and eth0/1). so my question is that if i have one copper hand off and that goes into eth0/0 and have two vlans on that interface. can i have the same failover using the vlan with sla monitor? or does that just work with physical interfaces?

1 REPLY
Anonymous
N/A

Re: ASA failover question

Both active and standby ASA's should have the same configuration which applies to VLAN also.

126
Views
0
Helpful
1
Replies
CreatePlease to create content