Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ASA question for IPSEC and SSL

I am trying to setup my home ASA to accept either IPSEC or SSL client connections so I can get used to configuring either of those two options.

On my home ASA, I am operating on a single IP address assigned by the ISP via DHCP.

When I tried to set this up in the past, I could get SSL to work (didnt try IPSEC at the time) but everything else I had working (I had some PAT redirection in place so that I could see one of two web based cameras I have around the house) quite working once I put the config in place for SSL.

Is what I want to do possible ?  Any suggestions on what I need to do to to get this to work ?

Thanks,

Ron

254
Views
0
Helpful
0
Replies
CreatePlease to create content