Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ASA's 5520's Active/Standby not syncing AnyConnect Profles

I'm working on configuring two ASA 5520's in an Active/Standby configuration.  I've got almost everything the same between the two units for AnyConnect to work expect the following two items:

     AnyConnect Client Profiles

     AnyConnect Client Software

If I upload the software manually to the Standby unit I get warning about them not being in sync and on the active unit if I do a 'write standby' it does not copy the profile or software.  Anybody have any ideas on this?

Thanks

Dan

1 ACCEPTED SOLUTION

Accepted Solutions

ASA's 5520's Active/Standby not syncing AnyConnect Profles

Hello,

Bug CSCsr31403

When configuring the ASA in a failover pair you must manually copy the  AnyConnect and CSD images to both the Primary and Secondary ASA devices.   You must also do the same for the Anyconnect profile file if it is  being used.

Either force the standby ASA to become active and copy the files to the  new active ASA using ASDM or copy the files directly from the standby  ASA console using tftp or ftp.

Regards,

Do rate helpful posts

Julio

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
2 REPLIES

ASA's 5520's Active/Standby not syncing AnyConnect Profles

Hello,

Bug CSCsr31403

When configuring the ASA in a failover pair you must manually copy the  AnyConnect and CSD images to both the Primary and Secondary ASA devices.   You must also do the same for the Anyconnect profile file if it is  being used.

Either force the standby ASA to become active and copy the files to the  new active ASA using ASDM or copy the files directly from the standby  ASA console using tftp or ftp.

Regards,

Do rate helpful posts

Julio

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
New Member

ASA's 5520's Active/Standby not syncing AnyConnect Profles

That worked, Thanks!

1577
Views
0
Helpful
2
Replies
CreatePlease to create content