ASA5510 RA-VPN using RADIUS to a 2008Windows Svr NPS
We are attempting to setup a 5510 to use Radius pointing to a windows2008 server to authenticate remote VPN users. I have set this up with 2003 using IAS but 2008 replaces IAS with NPS. Attached is the meat and potatoes of the config and aaa server logs. It seems that the ASA is attempting to connect to the server but not receiving any response. I'm not sure if we would be better to leverage anyconnect ssl connection vs the Cisco VPN client, any suggestions would be appreicated.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...