Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ASA5510 SSL VPN Client (Tunnel Mode) setup

Hi,

I'm new to SSL VPN and the ASA5510. I've setup a test network with the ASA5510 and can browse to the login screen.

But after I logged in and installed the certificate, I'm getting the following message:

"The SSL VPN Connection was terminated by the remote peer and could not automatically re-established. A new connection requires re-authentication and must be started manually. Close all sensitive networked applications."

Can anyone shed some light on this message? Is it a browser setting issue? Or the ASA5510 config?

I used the "SSL VPN Client (SVC) ON ASA Using ASDM Configuration Example" doc as a guide to configure the ASA5510.

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a008071c428.shtml

Thx

2 REPLIES
New Member

Re: ASA5510 SSL VPN Client (Tunnel Mode) setup

Try this:

1.Regenerated the ssl certificate:

for example:

asa5510(config)# crypto key generate rsa general-keys label ASA5510

modulus 1024

2.Changed SSL protocol to use Negociate ssl v3/TLS v1

e.g: asa5510(config)# ssl client-version any

3.Uninstalled and re-installed the ssl client.

e.g:

asa5510(config-webvpn)# no svc image disk0:/sslclient-win-1.0.2.127.pkg

asa5510(config-webvpn)# svc image disk0:sslclient-win-1.0.2.127.pkg 1

New Member

Re: ASA5510 SSL VPN Client (Tunnel Mode) setup

check the asdm logs for the reason. Most likely you did not set the address pool for the ssl vpn to use an internal address range.

1448
Views
0
Helpful
2
Replies
CreatePlease to create content