Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Bandwidth needed for IPSec tunnels

Hi All,

I have to install an ASA 5520 and configure approximately 600 Site-to-Site IPSec tunnels. My question is... how much bandwidth is needed for this to work? How much bandwidth approximately consumes each tunnel? Is there a way that I get a number?

Thank you!

1 REPLY
Cisco Employee

Re: Bandwidth needed for IPSec tunnels

The bandwidth on each tunnel can vary. It all depends on how much traffic is being pushed through the tunnels. You can monitor the traffic using SNMP.

152
Views
0
Helpful
1
Replies
CreatePlease to create content