01-05-2006 01:43 AM - edited 02-21-2020 02:10 PM
Hi,
wondering if someone could shed some light as to where I could be encountering a problem with my DMVPN config.
I have a very basic setup with no NAT setup in a lab environment and cannot seem to get the VPN tunnels up. R1 is the hub and R2 is the spoke.
find attached a copy of the configs from both routers aswell as a debug crypto isakmp.
any guidance would be appreciated
Thanks in advance
Solved! Go to Solution.
01-05-2006 02:49 AM
Hi there,
You have attached your tunnel-interfaces to FastEthernet0/1, while it seems to me it's FastEthernet0/0 which is to be used.as the VPN-headends
You should also remove your route pointing the 10.0.0.0/24 network out Fas0/1
Did it help? If so, please rate it.
01-05-2006 02:49 AM
Hi there,
You have attached your tunnel-interfaces to FastEthernet0/1, while it seems to me it's FastEthernet0/0 which is to be used.as the VPN-headends
You should also remove your route pointing the 10.0.0.0/24 network out Fas0/1
Did it help? If so, please rate it.
01-05-2006 04:13 AM
Thanks for your reply, bad oversight by me but many thanks for the assistance.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: