VPN

I have a newly installed 5505 ASA device - and I am not that familiar with it yet.  In fact, I only have a moderate level of experience in configuring routers at all.We have an outside vendor who requires access to a phone device inside our network (...

Hello Everyone,Does CISCO have a preference as to what MODEM I need to use to connect ot the Aux port for a 2811 router?  I have a USR 56K Fax/Modem connected but not performing a handshake.THanksAlfred

Hi,I want to do a remote dial in to Cisco 2811 Terminal Router over AUX.I am not able to connect whenever i dial i only get the dial tone i had attached USR modem to the AUX port of the Router Terminal Router Configversion 12.4service timestamps debu...

Hi,Actually I have to make a VPN between an 5520 ASA and a Cisco 887VA-K9 Router. Connected to ASA I have the outside interface, the inside-DMZ interface, the PCs interface and the VoIP interface. In the other site I will need to have a new subnet an...

Can anyone tell me why my xml file validation when appling it to my Anyconnect profile.

Can any VPN user change their user account password through tunnel which configured on local database of ASA 5510?

Hi AllGot a classical remote access vpn with Cisco VPN Client and ASA-5520Some weeks ago I noticed in my ASA logs this severity 5 Message.Group = xyz, Username = abc, IP = 84.n.n.n, Duplicate Phase 2  packet detected. No last packet to retransmit.Thi...

Hi dear. I want to configurate cisco ipsec vpn client at asa 5505. At my asa the software version is 8.4.please provide me a link or some material to config ipsec vpn client at asa 5505 version 8.4thank you.

The ASA "track" command can use an SLA, but it looks like SLA monitor only supports ICMP type as a health check.  We would like to redistribute and use a static route only if the appropriate VPN link is up.We have multiple sites, each with an OSPF ar...

I have an ASA5510 that I am trying to set up for remote access using SSL VPN & clientless SSL VPN. I have followed the config guides on the Cisco website as well as the config guides elsewhere on the internet to no avail. I have a TAC case opened and...

Does ASA support bringing up a password change dialog box for a user with _JUST_ clientless WebVPN session, via a browser? What is required for this? Do I have to configure some sort of custom change password webpage?thx,W