VPN

Hello,I have always been using my 1211 as remote users VPN gateway to access local LAN.ehre is the netork scheme------- 192.206.x.25 --| c2811 |---131.151.x.254being 192.206.x.25 the IPA ddress on the WAN interface and 131.151.x.254 the IP Address on...

Hey guys,Quick question.I have a Cisco ASA 5505 which is setup as an EasyVPN client to e remote VPN concentrator.The Cisco ASA has the 50 internal user license with 10 VPN peers.We just upgraded the license from the base 10 internal user to 50 user l...

I have a Cisco RV042 installed at our main office. This router is connected to a Netgear GS108 unmanaged switch. There are two PCs and a networked laser printer connected to the Netgear switch.At a satellite office I have installed a Cisco RVS4000, w...

I have an ASA 5510 with about 30 users behind it (I'll call this site HQ) and an ASA 5505 with about 10 users behind it (I'll call this the remote site). They are setup with a site to site VPN between them.The users at the remote site need to join th...

Hi,I am facing a problem with transmitting of VoIP traffic through VPN.Scenario:    I have a 1921 router in my end where two ISP's terminate and load balancing is done over the ISP'S. I also have a site-to-site IPSEC VPN connection to remote location...

Hi guys, I have a question that if you could answer, I would be very grateful for. I'm trying to architect a design that encomapsses DMVPN with WAAS and ACE, and the deployment scenario is as follows:- DMVPN: Phase 3 with remote site routers and two ...

I have scoured the internet for hours without any leads, i wanted to see if it was possable to route data comming in from tunnelA to TunnelB if the destination is on that network, kind of like a hub and spoke topology.Im looking to be able to have si...

my english is poor,there is a problem with my VPN.it is the same problem with gre over ipsec:https://supportforums.cisco.com/message/3358857#3358857.in my side,there is a 2851:when i apply the crypto map in the GRE tunnel interface this type of messa...

Hello,I would like to know if I can download the Cisco Anyconnect client for windows while I want to set up a vpn connection for windows. I have the cisco asa 5505 for the vpn set up. Should I have any specific permissions to donwload this particular...

If I use a browser to administer the router and simple click the save changes button on any page, it will allow the viewer program to connect to my remote dvr again for a random time(usually once daily). I have put the static IP of the viewers comput...

Is it possible to remove the high encryption (k9) from an Asa and make it into k8 model?

Hello, I am 17 routers Cisco 837 With Cisco IOS Software, C837 Software (C837-K9O3SY6-M), Version 12.3(2)XE4, RELEASE SOFTWARE (fc1) My tunnel is mounted but falls after 1 day is there a way to automate the recovery of the tunnel without rebooting th...

Hi, We have an ASA 5505 and its configured to use a Freeradius server that  authenticates against openLDAP. I'm trying to configure Dynamic Access  Policies to restrict access based upon what group a user belongs to.  In  LDAP I have an attribute cal...