VPN

I have an IPSec VPN between two 871's.  For some reason throughput through the VPN is much slower than throughput to internet sites.  Is this typical behavior or, are there some optimizations that need to be done.  The CPU usage on the routers is onl...

Hi I have two asa 5500 with a site to site tunnel. Everything on the small location works fine. But from the large location we cannot ping the host on the small location and vice versa. The small location can use internet over the large location. But...

Hi,we are having Cisco ASA 5510 appliance which is having Outside, inside and DMZ zones. we are having set of public IP pool. For example out side interface is having 1.1.1.1 public IP and 1.1.1.2 is free IP, not using any where. i want to access Mob...

Hi, I am trying to set up a site to site VPN between ASA 5520 and the check point firewall using the site to site VPN tunnel wizard from the ASDM. The checkpoint firewall is configured by the technicians on the third party site. we verified that all ...

Hi Community,hoping you can help here. We currently have an ASA in place with a single outside interface (public ip address) used for our Site-to-Site VPNs, our Dynamic VPN Clients, our publicly reachable servers and, of course, our outgoing traffic....

Dear allI LIKE TO KNOW CISCO ROUTER 2821-SEC/K9 HOW MANY DMVPN TUNNELS CAN HADLE ?, AND I LIKE TO HAVE 225 TUNNELS ANY ONE SUGGEST ME WHAT I WILL DO ?

I am already using soft VPN configured on my Cisco 2811 Router, I heard that the normal VPN license is only for 10 concurrent users but I never tried to connect more than 10 users at the same time,  I want to give remote access to my company users (m...

HI,we have a site to site VPN with branch office and head office in that we are able to access all nodes in the head office except 2 or 3 IP'sthese 2 or 3 IP's are already static nated for outside web access on the same PIX firewallthe VPN config as ...

Hi all,I would like go to internet via central office through a ipsec tunnel but i can not NAT origin traffic in central office because my ipsec inbound interface is the same of my internet interface.Remote Office          <--------- IPSEC site to si...

Hi,Was wondering if someone could point me in the right direction. I have a Cisco 5505 and 5510 ASA device. I want to setup VPN on it so that it talks with and authenticated through our Active Directory. Is this possible? If so can anyone point me to...

Hi,I have ASA 5520 and have created subinterfaces and configuring remote access VPN. For single sub interface i am trying to enable both IPsec and SSL VPN. SSL VPN is functioning  whereas i am not able to connect to IPSec Gateway. Debug message indic...