VPN

one of interfaces is suspended. total ports in the channel is 4. the other 3 are fine. %EC-5-CANNOT_BUNDLE2: Gi0/24 is not compatible with Gi0/22 and will be suspended (speed of Gi0/24 is 100M, Gi0/22 is 1000M under sh int status, the Gi0/24 is 100M....

Hi - I have an ASA5520 with IPSEC and SSL VPN setup. All works fine if I am content with accessing the inside network, but I also want to access the network in the subnet called "store". The security level is set to 90 on this interface but I cannot ...

Hi All.We are in the process of upgrading our remote access server, and part of this is moving from ACS 3.3 to 4.2What is the best way to export the DB? CSUTIL.EXE? Cheers!Ben

How can we setup access to manage the pix (ssh and asdm) over a vpn client connection? We have given access to the pix via ssh and asdm to the VPN sunbet, but cannot access the pix. The commands we entered are below:ssh 111.111.111.0 255.255.255.0 ...

Hello all, Trying to migrate our L2L VPN connections from our 3030 concentrator to our ASA 5520 running 8.0(3). It looks to be trying to establish our test tunnel. But we get the following error on the remote end: *Jun 11 16:13:15.740: No peer s...

do i just configure a new cryptomap and add it to the second interface? will it interfere with the vpn cryptomap configured on the outside interface?do i need to create a new nonat acl?do i then have something like:nat (inside) 0 access-list InsideNa...

HiI am looking to use the AS5350xm to answer i/c PSTN / ISDN data calls. Is there anyway I can capture and forward the ANI & DNIS information over either IP ot XOT for remote archive purposes?

Hi,I have customer router connected to ISDN gateway.ISDN is configured as backup for main line.Now on the Customer router unwanted incoming call are getting even if ISDN gateway is not intiating the call.This is getting disconnected after 20sec.When ...

Hi, If i want this signature to produce alert when recieve packet size within range 2000-3000 only, i will modify the packet size length for this range. My question is it need to make this value as 2000-3000 or there is an offsec i should keep it on ...

Currently we have ASA 5510 in place and would like to establish a VPN tunnel to Cisco 877 router. Being that is the case, the 877 router has dynamic IP. Is there a secure and recommended way to configure and establish a hard VPN tunnel between 5510...

I'm trying to configure the second primary rate controller port, however this controller fails to connect successfully to the remote modem. It however successfully rings the telephone line. If I use the first primary rate port (controller E1 1/0) a c...

Hello,We are using an ASA 5540 to allow remote users access over an SSL VPN. We would like to provide Web mail access, but it must be encrypted ( SSL ). This is possible, but the problem arises when you want to scan this ssl traffic with a CSC SSM mo...

Hi all, I have an 837 and on the spec sheet it says it can do URL filtering, but I cannot find the option in configuration or in the 837 user guide.Any ideas?

Hello,I have a config question for those who's working with the uBR10k.I have a 10k with 2x wan uplink cards (ESR-HH-1GE) GigabitEthernet3/0/0 and GigabitEthernet3/1/0Those links are connected to 2x cat2960G (.1Q trunk between them) where each c2960 ...