VPN

Hi, I have a Cisco Pix 515 and a Concentrator for the VPN side. I'm getting rid of these 2 and replacing them with 2 ASA 5520 (active/standby). I hope to eventually move the site to site VPN's and client VPN's over at some point and hope it's like ...

In a scenario, there are two global IPs one is with static NAT and is used for VPN, the other one is with dynamic PAT and is used for non VPN traffic for a different client. How ever the source is same for both the cases.Will there be any issues on t...

Hello all. I have a 2821 router that I have Telephone lines connected to the modem card ports. Authentication is done by RADIUS. there are two types of service that can be used by dialup users. that is, prepaid and postpaid. The RADIUS requires t...

Hi,I've setup SSL VPN with automatic download of the SSL VPN client to the user.However, when logging in on the web interface I get the error:"Unable to send authentication message"Does anyone know what that means? BTW, I use the LOCAL group for auth...

Trying figure out which product to use and am looking at both the 857 and 877 but unsure if they will do the job or not.I want users to be able to connect to a SBS2003, with routing and remote access enabled, on a private subnet 192.168.x.x through a...

We want to do the following:1) Deploy several asa5505 that are behind a NAT router that has a dhcp public ip. (we dont have control over the internet connection at the sites).So the asa's have a private ip (192.168.0.107) like every other pc on that ...

I am attempting to set up a site to site VPN with a Checkpoint firewall without much success. My end is a failover pair of PIX 515e firewalls running 6.3(5). Both have a 3DES license. My understanding of failover is the primary has an outside addr...

Hi,We have a LNS which is connecting to our partners LAC. I've been mandated to provide password authentication for this connection. Looking online, all that I see is authentication for the users that will be using the LAC/LNS connection. But... I...

IOS - 12.2 18 SXFcrypto isakmp client configuration group keeps the count of dropped vpn connnections (those which are dropped due to internet failure on Client part and not disconnected properly)Though this does not block the IP from pool and client...

Hi,We are having ASA 5510 series and on which we have configured remote VPN. So user uses VPN client installed on PC and connects to ASA , he is authorised and a temporary ip address from a pool is given to him. Then he can access intarnal resources...

HiI'm having a smaller problem and need some help to clarify it.I'm NAT'ing my inside to my external interface when passing traffic through the VPNSoaccess-list vpn extended permit ip external_interface 192.168.20.1 255.255.255.0I get hitcounts on th...

I'm looking for a place where I can download the Cisco VPN client. I do not have a maintenance contract and cannot sign into CCO to download software. I do work for a client that uses the Cisco VPN client for remote connectivity. I asked them for ...

when setting up a PIX to PIX vpn over say an internet connection, what should you expect to see in the show ip route statement?Would anything be added or does it operate using the access-lists alone and default external route?Thanks.