Hi,I would like to know what are the ports and protocol that i need to allow from the cisco PIX to reach our VPN 3000 concentrator for my remote users ip Regards,Vinoth
Hello Cisco Gurus,I have a 1721 at my T1 which terminates all of the VPN tunnels and NAT's all addresses. When clients tunnel in they are able to establish a connection and browse network resources but sometimes it runs very slow. Other times they ca...
I have a client that is attempting to both firewall, and VPN (remote access and site to site) functions on a single 5510 unit. They seem to have problem when the Internet bandwidth becomes congested and the remote access VPN user suffer badly from p...
i am able to vpn in just fine however i'm unable to access any network resources (i.e. files, email, etc). when i go up to status --> Statistics i've noticed that in the the transport section the transport tunneling = Inactive. i test with another P...
Hey Netpros:I'm having some difficulty finding good info on this topic.Specifically, I've got an ASA that is used solely for SSL VPN access by users. I would like to register a public cert so the users aren't prompted with certificate errors when th...
hi I have a problem with a vpn that access to my pix 515e the problem is the following i only can connect to my corporate network if the pix is configure with an internal address pool if i configure the pix to get an ip address from my internal dhcp ...
All, I try to connect to my ASA VPN head-end device from GPRS Internet connection, GSM provider allocate address from 10.0.0.0/8 and in my network I also use the 10.0.0.0/8 networks,also client get address from this private range . I can establish th...
Hi :-) - Thank god I found this Forum :-)I have to set up a site-to-site vpn between the 2 mentioned deices (and their networks behind).But I have not found any decent docs on how to set this config up. I have found many, also the "software config ma...
Hi Hope somebody can help. I'm trying to use a new ASA 5520 to terminate my remote access VPN's. The remote clients use the cisco VPN client V5. I'm using the configuration below and testing using a laptop directly connected into the same VLAN as the...
Pretty weird problem I discovered recently.We use the VPN Client to connect to a 1841 router. Everything works fine except for one small thing.The client do not send out _any_ traffic if the destination is the ip-address of the DHCP-server the client...
HiI got a Cisco VPN Client Initiating a VPN connection behind an ASA Firewall(8.0.2) to a PIX (7.0) across the internet , the VPN is establish with IP but cannot ping the resources behind the PIX.With the VPN client behind any internet cafe/starbucks...
I having problem configuring access to external web access(Internet) and internal shared folders (i.e. map department and home drives) while I connected to network via VPN. I am to do terminal services and ping the serves but not able to map drives ...
Anyone here ever use or configure a IPSec VPN SPA in a 6500 for terminating a large number of users (~6000)?? I posted this just to hear some thoughts on it. Thanks!-Lloyd
Able to establish VPN remote access tunnel between 3030 and 781 router but only see TX bytes. No RX bytes. from behind the 781, can ping the host behind the 3030 concentrator. But TX bytes do not update. Please advise. Thanks.
