Hi All,I had to set up a new vpn group on my asa 5510 box. I created the new tunnel group with a new pre-shared key. i also set up a new local user account. i tested this connection and it worked fine. well today, when i try to use it..it states ...
Good day...I have a IOS (tm) C2600 Software (C2600-IK9O3S-M), Version 12.3(10), RELEASE SOFTWARE (fc3). I was trying to set up a VPN connection when I found out that I'm unable to ping any new public ip addresses. I can go to any router on the netwo...
We have a new cisco 3825 router that we use for site-to-site vpn's. Several of the vpn's need to access the same internal host. On one of the VPN's we are nating this particular internal host to the outside. On several other VPN's that need access to...
We have a new cisco 3825 router that we use for site-to-site vpn's. Several of the vpn's need to access the same internal host. On one of the VPN's we are nating this particular internal host to the outside. On several other VPN's that need access to...
I'm currently configuring a Cisco ASA.I have setup a IPSec VPN tunnel between a VPN Client and my ASA.My VPN POOL addresses: 10.10.10.0/24My LAN network: 192.168.0.0/24After applying an access-list on my incoming inside traffic (inside_access_in) I c...
We have a Pix 515e, while users establish vpn they cannot browse the internet. Is there a way to enable internet browsing through the pix without split tunnel?
Hi netpro: I have some trouble when I config a pix515 for vpn client. the vpn client can establish with pix and it get a address from pix pool ,but the client can't ping the hosts in the dmz and pix's dmz interface.the config :vpn# sh run : Saved:PI...
Hi Guys,Please help, is anyone tested or knows how to configure the Pix 515E site-to-site VPN with Linksys BEFSX41? As of this time, i'm using cisco vpn client to have a vpn tunnel (running and operational) to our head office but we are planning to i...
I have a PIX 515e and setup VPN to go through the PIX 515e. Right now the user can not browse the internet while connected to the VPN. How do I allow user to browse the internet while connected to the VPN without compromising security risk?
Hi,We are having standard Cisco three layer network design consisting of access layer routers , distribution layer and core layer routers. We plan to form VPN/ IPSEC tunnel from access layer router to Core layer that is one end is access layer route...
My first time configuring ISAKMP/IPSEC, how does it look?hostname 1720!ip host router2611 5.x.x.1crypto isakmp policy 1000 authentication pre-share group 2crypto isakmp key thisisacryptokey hostname router2611crypto isakmp identity hostname!crypto ip...
I have 80 branch offices in which have 831 routers with US Robotics modems connected via console port for out-of-band dialin. My problem is my service provider can dialin and make configuration changes with no problem however I am unable to. I have u...
I have a user that gets an application error when launcing the SSL VPN client:Faulting application Agent.exe, version 1.1.0.154, faulting module unkown, version 0.0.0.0, fault address 0x206c6544This is logged in the application event log under Applic...
I tried to configure SVC (tunnel-mode) on ASA 7.1(2) and I reach the stage where I can connect with the SSL VPN but I can?t access any resources in the network.Below is the configuration, appreciate any helpful assistance.. access-list WebVPN-ACL sta...
