Bridging users across a Split Tunnel Configuration
We have a site where we have a split tunnel configuration setup. One side of the connection has users on a specific IP network, only accessing the Internet to get to select applications in the cloud.
The other end of the split tunnel has users on a separate IP network that are forced down a Site-to-Site tunnel back to the Data Center to get to other application resources.
The problem is at given times, the users that are on the Internet/Cloud connection need to be routed over the forced Site-to-Site VPN tunnel side of the connection in order to access applications in the Data Center. Essentially setting up a bridge between to the two networks over the Split Tunnel configuration.
We are looking for the easiest option to get this accomplished.
If anyone has had to do this type of setup in the past, we would appreciate if you could share the configuration that you used to accomplish this task.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...