Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

can't connect using anyconnect!

Hello guys! I just installed a new asa 5505 and I had to configure the  asa myself until my smartnet is activated and the asa is up and reunning  on my network, however when iI try to connect using cisco anyconnect it  fails and I get this error. Can anyone explain what is wrong with my  configuration?

Everyone's tags (4)
3 REPLIES
New Member

Re: can't connect using anyconnect!

Is the firewall on on your pc? - turn it off or AV

Are you outside the network?

Sent from Cisco Technical Support iPad App

New Member

can't connect using anyconnect!

yes i'm outside the firewall

Cisco Employee

can't connect using anyconnect!

Hi,

I went through the error message and I see that the error says: No address available for svc connection. Please make sure that you have address pool defined on the ASA for the Anyconnect connection.

Please reference this link for configuring Anyconnect on the ASA: http://www.tech21century.com/how-to-configure-anyconnect-ssl-vpn-on-cisco-asa-5500/

In this link, you will find commands like this:

! Create a local IP address pool to assign for remote users

ASA(config)# ip local pool SSLClientPool 192.168.100.1-192.168.100.50 mask 255.255.255.0

and this has been assigned to the connection profile like this:

ASA(config)# group-policy SSLCLientPolicy internal

ASA(config)# group-policy SSLCLientPolicy attributes

ASA(config-group-policy)# dns-server value 192.168.5.100

ASA(config-group-policy)#vpn-tunnel-protocol svc

ASA(config-group-policy)#address-pools value SSLClientPool

Please check these steps and you will be able to connect successfully.

Let me know if this helps.

Thanks,

Vishnu Sharma

3327
Views
0
Helpful
3
Replies
CreatePlease login to create content