Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

New Member

Can't telnet to pix through vpn

I setup a remote access vpn on our pix using version 634. The vpn works fine. I also setup the command management-access inside on my pix and i did a show management-access to make sure that it was there. After connecting to the lan through the vpn i tried to telnet to the pix but i keep getting this error, "connecting to 192.168.1.5 . . . could not open connection to the host, on port 23: connect failed. Is there something else i am missing. I don't have split tunnel enabled on the pix. Any help would be much appriciated.

Thanks,

Lake

  • VPN
2 REPLIES
Gold

Re: Can't telnet to pix through vpn

keep the management-access command, and add the command "telnet inside"

New Member

Re: Can't telnet to pix through vpn

Hi Jackko,

It worked. Thanks again for your help.

Regards,

Lake

352
Views
5
Helpful
2
Replies