Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

change inside interface speed for pix 501

Hi,

For some reason I can't change the speed on the inside interface on the pix 501. Whenever I try to use the command (interface ethernet1 10full) it comes back with the message: "ethernet1 can only be set to 100full".

Is there a way to change the speed? I need to do this beause of an mck box for voice over ip, it only works on 10baset network speeds.

Thanks

2 REPLIES
New Member

Re: change inside interface speed for pix 501

As far as I know you can't do it because it is a four port unmanaged switch, not a single ethernet.

New Member

Re: change inside interface speed for pix 501

Hi, Try to set 10Half or leave it in auto mode. It will negotiate the Speed & duplex with peering device like phone/PC whatever.

Ninja

397
Views
0
Helpful
2
Replies
CreatePlease to create content