Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Change UDP port for NAT-T during L2L between two Cisco 3000 Concentrator

Is it possible to "drive" the negotiation of the udp port used by the two concentrators during L2L connection and NAT-T?

It would be very useful in my setup to have the L2L using udp/10007 rather than udp/4500.

Thank you.

1 REPLY
Gold

Re: Change UDP port for NAT-T during L2L between two Cisco 3000

i don't think the nat-t port can be manipulated.

couple alternatives i can think of is to use tcp over ipsec, and then you will be able to use whatever port you prefer; or you may configure port forwarding on the router/firewall in front of the concentrator.

107
Views
0
Helpful
1
Replies