cipSecTunnelStop (184.108.40.206.220.127.116.11.18.104.22.168) - This notification is generated when an IPsec Phase-2 Tunnel becomes inactive..
I am receiving below SNMP trap.
CISCO-IPSEC-FLOW-MONITOR-MIB::cipSecTunnelStop (22.214.171.124.126.96.36.199.188.8.131.52) - This notification is generated when an IPsec Phase-2 Tunnel becomes inactive.. Varbinding Details: [ System Up Time = 65 days, 20:30:30.00 ]
[cipSecTunActiveTime - The length of time the IPsec Phase-2 Tunnel has been active in hundredths of seconds..17 = 568737300 ]
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...