In our lab, we have one Cisco a-mode AP with model no: AIR-AP1230A-A-K9. Right now, it is supporting Qos and WPA. I wish to upgrade AP so that it will support WPA2 also. Which is the tar file for this particular service? What are the procedures for upgrading AP?
I have tar file: c1200-k9w7-tar.123-2.JA2 and I am using tftpd32. But after upgradation of Cisco A mode AP, I checked the firmware name. It is the new one. But still it is not supporting WPA2. I have a doubt that the particular model (AP with model no: AIR-AP1230A-A-K9.) does not have hardware capacity to support WPA2. Please check this and send me a reply as soon as possible, because our work is stuck in middle.
The a radio module required for supporting WPA2 is AIR-RM21A or AIR-RM22A. In case the radio module on this AP is AIR-RM20A, then it will support only WPA. Kindly check the radio module using 'show controllers'.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...