I am pretty new to Cisco programming and am trying to get an SSL VPN set up for remote access using a web browser and using Anyconnect version 3.1.04509. If I try to connect via a web browser I get an error telling me the security certificate is not secure. If I try to connect via Anyconnect I get an error saying "Untrusted VPN Server Blocked." If I change the Anyconnect settings to allow connections to untrusted servers, I get two errors that say"Certificate does not match the server name" and "Certificate is malformed." Below is the running config in the router at this time. There is another Site-to-Site VPN tunnel that is up and working properly on this device. Any help would be greatly appreciated. Thanks
Current configuration : 7741 bytes
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
logging message-counter syslog
no logging buffered
enable secret 5 XXXXXXX
enable password XXXX
aaa authentication login default local
aaa authentication login ciscocp_vpn_xauth_ml_1 local
aaa authentication login ciscocp_vpn_xauth_ml_2 local
aaa authorization exec default local
aaa authorization network ciscocp_vpn_group_ml_1 local
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...