Alternatively I've setup a site-to-site VPN between the two devices but keep getting "%CRYPTO-4-IKMP_NO_SA: IKE message from x.x.x.x has no SA and is not an initialization offer", so it doesn't complete phase II.
I've reloaded both devices and cleared all old SA's with no luck.
Re: CISCO 871 as Server to ASA 5505 as client OR assist with sit
No, the PIX is DHCP too on the same line.
The 871 is planned to replace the PIX, so I simply unplug the WAN connection from the PIX, plug it into the 871 and reload / no shut the WAN interface on the 871 to obtain the DHCP address - DHCP address is the same each time so far.
I know the configs are slightly different between the two in terms of syntax etc., but it doesn't make sense the SDM on the 871 doesn't work properly - thi sis also with a 'clean' config i.e. write erase the 871 and start with only internet access (nat), then apply the site-to-site wizard.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...