I have a Cisco ASA 5505 with active and standby interfaces. I was able to configure AnyConnect through the active interface, authenticate through RADIUS, and access network resources. I would like to do the same on the standby interface.
I added a "backup" server but no luck. I even tried configuring the standby interface using the same steps as the active interface but no success.
Redundant interface. Cisco VPN client works on both the active and standby interface. Cisco AnyConnect works on the active only. I'm puzzled as to why it won't work on the standby once the active interface has been disconnected.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...