Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco AnyConnect Secure Mobility Configuration Assistance

Hello!

A partner of CIsco from Singapore is asking if this would be possible on Cisco Anyconnect Secure Mobility

If I wish to use the "Cisco AnyConnect Secure Mobility" in the Anyconnect 3.0, can i configure that the user is not able to access any traffic via its wireless card when the VPN is established via the wired LAN port. i want to prevent any bridging between these two network ports when the VPN is up.

In addition, can I enable split tunneling so that all traffic needs to go thru the VPN tunneling?

Regards!

Ice Flancia

Cisco Partner Helpline Tier 2 Escalations Team

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Cisco AnyConnect Secure Mobility Configuration Assistance

To route all traffic towards the VPN tunnel, split tunnel needs to be disabled (not enabled).

Under the group policy configuration: split-tunnel-policy tunnelall

Once split tunnel is disabled, the VPN users won't be able to access any of his/her local LAN networks anymore (including the wireless network).

Hope that helps.

2 REPLIES
Cisco Employee

Re: Cisco AnyConnect Secure Mobility Configuration Assistance

To route all traffic towards the VPN tunnel, split tunnel needs to be disabled (not enabled).

Under the group policy configuration: split-tunnel-policy tunnelall

Once split tunnel is disabled, the VPN users won't be able to access any of his/her local LAN networks anymore (including the wireless network).

Hope that helps.

New Member

Re: Cisco AnyConnect Secure Mobility Configuration Assistance

Thanks!! Appreciate your quick response!

238
Views
0
Helpful
2
Replies
CreatePlease login to create content