02-08-2012 01:09 AM
Hello,
I've setup the vpn on my Windows Server 2008 R2 box, I now need to do the firewall part - whats the easiest way of doing this as I can see there is a VPN Wizard on the PIX, or can I just open up the ports on the firewall?
Thank you.
02-10-2012 11:41 AM
any ideas?
02-10-2012 03:58 PM
I've managed to run through the wizard and connect to the vpn fine now.
there is one problem, when i am connected to the vpn i cannot browse to the remote network, any ideas?
02-10-2012 06:15 PM
you need to nat exemp traffic on Pix
sh run | inc nat
paste your configuration file. I can assist you further
varinder
02-11-2012 05:47 AM
Result of the command: "sh run | inc nat"
access-list inside_nat0_outbound extended permit ip any 192.168.1.176 255.255.255.240
access-list inside_nat0_outbound extended permit ip any 192.168.1.168 255.255.255.248
access-list inside_nat0_outbound extended permit ip any 192.168.1.32 255.255.255.224
access-list inside_nat0_outbound extended permit ip 192.168.1.0 255.255.255.0 192.168.1.96 255.255.255.224
nat (inside) 0 access-list inside_nat0_outbound
nat (inside) 101 0.0.0.0 0.0.0.0
02-13-2012 05:05 AM
Any ideas?
We are using Cisco VPN Client - 5.0.07.0410 if that helps.
02-21-2012 01:24 PM
anyone?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide