09-04-2012 01:52 AM - edited 02-21-2020 06:18 PM
Hi,
on cisco router we configured remote access vpn but after configuring
ip cef command split tunneling stopped working
So please anybody have any solution
interface Loopback 0
ip address 10.1.1.1 255.255.255.0
ip access-list extended ACL-OUTSIDE-PBR
deny ip 10.9.0.0 0.0.0.255 10.10.10.0 0.0.0.255
route-map RM-OUTSIDE-PBR permit 10
match ip address ACL-OUTSIDE-PBR
interface FastEthernet 0/1
ip access-list extended ACL-POLICY-NAT
permit ip 10.9.0.0 0.0.0.255 any
p access-list extended ACL-POLICY-NAT
ip access-list extended SPLIT-TUNNEL
crypto isakmp client configuration group vpnsplit
key *********
dns 4.2.2.2
acl SPLIT-TUNNEL
pool VPNSPLITPOOL
Nil
09-04-2012 02:06 AM
Sounds like a bug to me if you enable "ip cef" and split tunnel stops working.
Pls upgrade your router to a later version and it should resolve the issue.
09-04-2012 05:00 AM
Hi,
I agree with Jennifer, an upgrade may fix the issue, but instead of going straight to it, could you please provide the "show ip route", "show run | inc ip route" and "show arp", during a VPN connection test?
I would like to verify a couple of things
Thanx.
Portu
Sent from Cisco Technical Support Android App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: