Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Clean up VPN users on ASA 5505

I have moved from the PIX to ASA world and while some things are similar, there are a few things that are quite a bit different. After using the VPNGROUP command to create VPN users, I have a very ugly config. Can someone help me clean this up? Everyone uses the same DNS/WINS servers, address pool, etc. User authentication is handled by the ASA.

group-policy user1 internal

group-policy user1 attributes

wins-server value 192.168.1.10

dns-server value 192.168.1.10

vpn-idle-timeout 30

split-tunnel-policy tunnelspecified

split-tunnel-network-list value split_tunnel

default-domain value superfancydomain.local

group-policy user2 internal

group-policy user2 attributes

wins-server value 192.168.1.10

dns-server value 192.168.1.10

vpn-idle-timeout 30

split-tunnel-policy tunnelspecified

split-tunnel-network-list value split_tunnel

default-domain value superfancydomain.local

group-policy user3 internal

group-policy user3 attributes

wins-server value 192.168.1.10

dns-server value 192.168.1.10

vpn-idle-timeout 30

split-tunnel-policy tunnelspecified

split-tunnel-network-list value split_tunnel

default-domain value superfancydomain.local

tunnel-group user1 type ipsec-ra

tunnel-group user1 general-attributes

address-pool CFPOOL

default-group-policy user1

tunnel-group user1 ipsec-attributes

pre-shared-key *

isakmp ikev1-user-authentication none

tunnel-group user3 type ipsec-ra

tunnel-group user3 general-attributes

address-pool CFPOOL

default-group-policy user3

tunnel-group user3 ipsec-attributes

pre-shared-key *

isakmp ikev1-user-authentication none

tunnel-group user2 type ipsec-ra

tunnel-group user2 general-attributes

address-pool CFPOOL

default-group-policy user2

tunnel-group user2 ipsec-attributes

pre-shared-key *

isakmp ikev1-user-authentication none

Any help is most appreciated!

226
Views
0
Helpful
0
Replies