cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
746
Views
0
Helpful
4
Replies

Clientless SSL VPN broken after upgrade 8.0(4) -> 8.0(5) ASA 5510

bvdijk
Level 1
Level 1

I've got 3 ASA 5510, upgraded them all from 8.0(4) to 8.0(5) and ASDM 6.2(3)

Then I found out none of the three device responded anymore to WebVPN,

like there is nothing listening to https on the outside interface

I downgraded one back to firmwate 8.0(4) and everything worked just fine again.

Any ideas?

4 Replies 4

RicheeJJJ_2
Level 1
Level 1

I'm experiencing this same problem today. Did you find a solution yet?

Have you backed up the all the config files of the appliance through

the utility into the asdm and restored it after the upgrade was done?

I've done the upgrade via the tools menu in  the Cisco ASDM, one whould expect that this should be the right way, since it was specially designed for upgrading.

(Ofcourse I make backups of my routers/firewalls etc. this is done on a daily basis by Kiwi Cattools)

Unfortunatly not yet, but I'm about to create a TAC request. When I've got the answer I will post it here.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: