Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring IPSec-Router to PIX

I have router Cisco3620 and PIX506E and i want to connect via VPN.

I found article "Cisco-Configuring IPSec between a router and a PIX using the nat 0 access-list command" and another solution using IPSec Tunnel ( using interface Tunnel ). When is better use each solutions , in which situations?

1 REPLY
New Member

Re: Configuring IPSec-Router to PIX

I am not sure I understand your question. The Pix wont terminate a "TUNNEL" (ie GRE) from a Router (this is what you would use interface tunnel for).

If this is just a basic Lan-to-Lan building an IPSEC tunnel between the Pix and the Router without NAT should be fine.

115
Views
3
Helpful
1
Replies
CreatePlease login to create content