There is a requirement to configure 2 gateway peers for a single tunnel. I dont see any command after "set peer" that would actually allow us to create a second peer for the tunnel. Is there a way to do this. Or if I give the command "crypto-map outside 10 set peer" the second time, will it create an additional peer for the tunnel
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...