Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configuring VPN between 2811 and RV220w routers

Looking for help in co nfiguring a VPN between a Cisco 2811 router on one end and a Cisco RV220W Wireless router on the other end.  I am familiar with the 2811 and it helps to us the CLI to see the config.  The RV220W appears to only have a GUI and I don't have access to the remote end, coordinating over the phone.

Pertinent config info for 2811 is as follows:

crypto isakmp policy 1

     encr 3des

     hash md5

     authenticaton pre-share

     group 2

crypto isakmp key XXXXXX address 76.11.xx.yy

crypto isakmp keepalive 10 3

crypto ip sec transform-set 3DES-SHA esp-3des esp-sha-hmac

crypto ip sec transform-set AES-SHA     esp-aes esp-sha-hmac

crypto ip sec transform-set 3DES-SHA-compress esp-3des esp-sha-hmac comp-lzs

crypto ip sec transform-set AES0SHA-compress esp-aes esp-sha-hmac comp-lzs

crypto map VPN-MAP-1 10 ipsec-isakmp

     set peer 76.11.xx.yy

     set transform-set 3DES-SHA

     set pfs group2

     match address Crypto-list

Interface FastEthernet 0/0

     ip address 98.141.aa.bb 255.255.255.248

     duplex auto

     speed auto

   

Interface Fastethernet 0/1

     ip address 192.168.2.1 255.255.255.0

     duplex auto

     speed auto

router eigrp 1

     network 192.168.2.0

     auto-summary

ip forward-protocol nd

ip route 0.0.0.0 0.0.0.0 98.141.aa.cc

RV220W is using the default IPv4 WAN (Internet) with DHCP which is not changing

VPN Advanced VPN setup 

     Direction/Type - both

     Exchange mode 0 agfressive

     Local Identifier type  - Local WAN (Internet IP)

     Remote Identifier type - Remote WAN (Internet IP)

     IKE SA Parameters

     Encryption Algorithm - 3DES

     Authentication Algorithm - MD5

     Pre-shared key - XXXC matches 2811 key

     DH Group - Group2 (1024 bit)

     SA-Lifetime - 86400

     Extended Authentication 0 XAUTH TYPE - none

Local Traffic Selection

     Local IP - Subnet

     Start Address 192.168.50.0

     Subnet Mask 255.255.255.0

Remote Traffic Selection

     Remote IP - Subnet

     Start Address 192.168.2.0

     Subnet Mask 255.255.255.0

Manual Policy Parameters

     SPI-Incoming - 0x (greyed out)

     SPI-Outgoing - 0X (greyed out)

     Encryption Algorithm - 3DES (greyed out)

     Integrity Algorithm - MD5 (greyed out)

Auto Policy Parameters

     SA- Lifetime 0 86400 seconds

     Encryption Algorithm - 3DES

     Integrity Algorithm - MD5

     PFS Key Group - enable - DH-Group2 (1024)

IPsec VPN Passthrough

     IPsec - enable

     PPTP - enable

     L2TP - enable

Can't seem to find a CLI on the RV220W.

Any help would be appreciated to make this VPN work.

Everyone's tags (4)
755
Views
0
Helpful
0
Replies
CreatePlease to create content