Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

crytpo ipsec client ezvpn, "virtual-interface"

Hi,

I'm working on getting a virutal tunnel interface up and running between two Cisco 2801 routers. I've found some docs about the IPsec Virtual Tunnel Interface which looks very promising but...

there are lines like this:

crypto ipsec client ezvpn CLIEN

virtual-interface 1

Every time I enter this in the console I get an error that it doesn't understand "virtual-interface" as command.

Is this something I need to enable via another command or anything? Or is it simply not possible in my IOS verion?

(I'm running: flash:c2801-advsecurityk9-mz.124-3f.bin)

Please help!

Looking online through the IOS command reference I also cannot find this as an option for the ezvpn client...

Thanks,

Sander.

3 REPLIES
Silver

Re: crytpo ipsec client ezvpn, "virtual-interface"

New Member

Re: crytpo ipsec client ezvpn, "virtual-interface"

If I enter that part into my router I get the following:

Enter configuration commands, one per line. End with CNTL/Z.

router(config)#crypto ipsec client ezvpn CLIENT

router(config-crypto-ezvpn)#connect manual

router(config-crypto-ezvpn)#group group1 key cisco123

router(config-crypto-ezvpn)#mode client

router(config-crypto-ezvpn)#peer 172.18.143.246

router(config-crypto-ezvpn)#virtual-interface 1

^

% Invalid input detected at '^' marker.

router(config-crypto-ezvpn)#username cisco password cisco123

router(config-crypto-ezvpn)#xauth userid mode local

router(config-crypto-ezvpn)#exit

router(config)#

So I get an error on the virutal-interface subcommand.

Any ideas?

New Member

Re: crytpo ipsec client ezvpn, "virtual-interface"

you need to create the bvi interface first then apply the crypto command to the virtual interface and the external facing interface of the router

crypto ipsec client ezvpn

connect auto

group remote_sites key xxxxxxxxxxxxx

mode network-extension

peer

username xxxx password xxxxx

xauth userid mode local

!

!

bridge irb

bridge 1 route ip

interface BVI1

ip address

crypto ipsec client ezvpn inside

interface Vlan1

ip address

bridge-group 1

bridge-group 1 spanning-disabled

try that, it should work

323
Views
0
Helpful
3
Replies
CreatePlease to create content