Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CVPN

Hello,

I am planning to connect system from my head office to a new branch office

through vpn connection by using VPN 3005 Concentrator at both sites.

The question: is it possible to configure the local network with the

network range? if so, how to configure on both CVPN to make vpn connection between both site

HO

M6550 192.168.2.10 255.255.255.0 Gateway 192.168.2.1

!

!

! 192.168.2.1 255.255.255.0

CVPN3005

! HO Public IP (ISP)

!

<>

<> VPN Tunnel

<>

!

! BO Public IP (ISP)

CVPN3005

! 192.168.2.2 255.255.255.0

!

!

M6540 192.168.2.20 255.255.255.0 Gateway 192.168.2.2

BO

Regards,

VIN

2 REPLIES

Re: CVPN

I am not too sure what your are asking .. but if the only thing you need is to estbalish a VPN .. then you can configure what is called lan 2 lan (L2L) VPN. Basically you need to agree on phase 1 and phase 2 parameters and configure them accrodingly from:

Configuration | System | Tunneling Protocols | IPSec | LAN-to-LAN

1.- Select on ADD

2.- Fill out the connection as needed. this is very simple as long as you configured similar parameters at the other end.

3.- One of the options allows you to specify the local nd remote network that will from the VPN tunnel. On this field yu can simply enter the range and WILDCARD mask or you can select them from network list. in which case you will have to define them BEFORE creaqting the VPn connection from:

Configuration | Policy Management | Traffic Management | Network Lists

I hope it helps ... please rate it if it does !!!

New Member

Re: CVPN

Hello,

Thanks for your reply. I think my question is a bit confusing. Anyway I have done the vpn configuration (L2L) and it works fine. But my question is it possible to config both local network are in the same network range?

192.168.2.0/24>>>cvpn_BO><><><>cvpn_HO<<<<<192.168.2.0/24

Regards,

VIN

620
Views
0
Helpful
2
Replies
CreatePlease to create content