ASA 5520 running 8.0(2), can't get asa to pass DHCP request to internal DHCP server. I've done serveral capture on inside interface and never see any request being forwarded. We normally use the microsoft vpn client, but I've tested with cisco client as well with same results. It is assigned at the group policy and the connection proffile to use DHCP, server and scope needed is identified. Please Help.....
MODE_CFG: Received request for DHCP hostname for DDNS is: x.x.x.x!
[IKEv1 DEBUG]: Group = xxxxx, Username = xxxxxxxx, IP = x.x.x.x, IKE received response of type  to a request from the IP address utility
[IKEv1]: Group = xxxx, Username = xxxxxxxxx, IP = x.x.x.x, Cannot obtain an IP address for remote peer
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...