debug on Pix 525 ver.7.1(2)

[sercopi]

Good evening I would know the correct command syntax to make the old command which I used with ver.6.3

With ver.6.3 I used:

pix#debug packet outside src remote_ip_address netmask 255.255.255.0 dst my_ip_address netmask 255.255.255.0 proto tcp sport any dport 20 both

What 'is the syntax in ver 7.1(2) ?

Any information that you can send me are welcomed!

Thank in advance

Davide

[m.sir]

You can use capture command

http://www.cisco.com/en/US/products/ps6120/products_command_reference_chapter09186a00805fb9bb.html#wp1993839

M.

Hope that helps rate if it does