Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Disconnection Problem in VPN Client v4

I have a problem of disconnection in the VPN Client, the VPN Client send a pop up indicate message 433 and some times 412, the connection without encrypted traffic it ok in all moments included to the VPN concentrator (ASA5520), in the AAA server the account is blank and the group is same.

add the configuration of the ASA5520 and attach debug an logs file

crypto ipsec transform-set myset esp-3des esp-sha-hmac

crypto ipsec security-association lifetime seconds 86400

crypto ipsec security-association lifetime kilobytes 4608000

crypto ipsec fragmentation before-encryption management

crypto ipsec fragmentation before-encryption Inside

crypto ipsec fragmentation before-encryption Outside

crypto ipsec df-bit copy-df management

crypto ipsec df-bit copy-df Inside

crypto ipsec df-bit copy-df Outside

crypto dynamic-map dynmap 19 set transform-set myset

crypto dynamic-map dynmap 19 set security-association lifetime seconds 86400

crypto dynamic-map dynmap 19 set security-association lifetime kilobytes 4608000

crypto map mymap 40 ipsec-isakmp dynamic dynmap

crypto map mymap interface Outside

isakmp identity hostname

isakmp enable Outside

isakmp policy 10 authentication pre-share

isakmp policy 10 encryption 3des

isakmp policy 10 hash sha

isakmp policy 10 group 2

isakmp policy 10 lifetime 86400

group-policy Intermedio attributes

banner value ACCESO RESRTINGIDO, SOLO PERSONAL AUTORIZADO

banner value

banner value ACCESSOS MONITOREADOS

dns-server value x.x.x.x

vpn-idle-timeout 120

vpn-tunnel-protocol IPSec

password-storage disable

split-tunnel-policy tunnelspecified

split-tunnel-network-list value Split-Inter

split-dns value aeromexpress.com.mx

webvpn

no functions

no html-content-filter

no homepage

no filter

no url-list

no port-forward

no port-forward-name

tunnel-group MXIntermedio type ipsec-ra

tunnel-group MXIntermedio general-attributes

address-pool MXINTER

authentication-server-group ACS LOCAL

no authorization-server-group

accounting-server-group ACS

default-group-policy Intermedio

no dhcp-server

no strip-realm

no strip-group

tunnel-group MXIntermedio ipsec-attributes

pre-shared-key *

no authorization-required

authorization-dn-attributes CN OU

peer-id-validate req

no radius-with-expiry

no chain

no trust-point

isakmp keepalive threshold 20 retry 2

1 REPLY
Bronze

Re: Disconnection Problem in VPN Client v4

Go to Start > Programs > Cisco Systems VPN Client > Set MTU.

Set the MTU to 1400 bytes (or lower). Check that you can use NetBIOS names. This is also used to check for dropped packets.

Go to Start > Run. Type ipconfig /all to verify that the VPN Client receives the correct WINS and DNS information from the VPN Concentrator. Check the even log for the VPN Client.

Verify that the PC that runs the VPN Client gets registered with the WINS and or DNS server through Dynamic Host Configuration Protocol (DHCP) correctly.

Verify that there are no filtering devices between the VPN Client and the resources you try to access. Ensure that the needed ports for Microsoft networking are allowed to pass

97
Views
0
Helpful
1
Replies