07-20-2011 01:46 PM
We have two ASA's 5540, running IOS 8.2(4). Is there a command to find out the password that we setup for VPN Load balancing? I recall there was a command that you type under CLI and it will display all passwords.
Thanks.
Diane
Solved! Go to Solution.
07-20-2011 01:49 PM
07-20-2011 01:49 PM
Here you go:
more system:running-config
Hope that helps.
07-20-2011 02:09 PM
Thanks for your prompt response, Jennifer. To remove the command, do you type "no more system: running-config"?
Thanks.
Diane
07-20-2011 02:22 PM
This command is like show running-config to view configuration of the device. But If you do more system:running-configuration you can view password, L2L tunnel pre-shared key etc.,
Hope I explained your question
Sent from Cisco Technical Support iPhone App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: