I have a (currently) 3 location fully meshed DMVPN. This will eventually be a 12 location DMVPN. The problem I'm having is if I reload the Hub router, the spoke tunnels never reconnect automatically. The only way I have found to make them reconnect is by connecting to the spoke routers via the CCP and under "Interface and Connections" and disabling then enabling the DMVPN Tunnel0, at which point the DMVPN's immediatley come back up. Obviously this required manual intervention is less than ideal. Is there a config setting I am missing that will fix this?
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...