Just to inquire, currently I have a setup whereby from the spoke router, i have 2 tunnels going to 2 hub routers in hq. tunnel 1 goes to hub router 1 and tunnel 2 goes to hub router 2. the phase 1 authentication used here is certificate currently. all these is working fine.
now, i would like to have one of the tunnels to run on pre-shared key. is this possible?
Note: TEST 1 using certificate & TEST 2 using pre-shared key.
tunnel protection ipsec profile TEST1
tunnel protection ipsec profile TEST2
is there any impact or concerns i should be aware off?? please kindly advice.
Ramraj Sivagnanam Sivajanam
Technical Specialist/Service Delivery Manager – Managed Service Department
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...