Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

DMVPN failover

I am having a problem with configuring 2 hubs in a dual DMVPN network.  I am able to connect all of the spokes to the primary hub, but whan I turn off the primary hub the spokes do not failover to the second hub unless I shut Tunnel0 on the spokes.  Does anybody know why this is working this way, I am including the hub config and one spoke config.

Thank you

1 REPLY

Re: DMVPN failover

It's probably not DMVPN related, sounds more like routing to me. Please do the following commands on the spoke when both hubs are online, and post it here

show dmvpn

show ip route

show ip eigrp neighbours

show ip eigrp topology

354
Views
0
Helpful
1
Replies
CreatePlease to create content