Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DMVPN Question

Does anyone know if it is possible to configure a router that is IOS DMVPN "SPOKE" to also be a IPSec remote access or Easy VPN client. Furthermore does anyone know of any documentation that shows describes an example of this set-up.

2 REPLIES
Silver

Re: DMVPN Question

I believe this can be done. The documentation is below.Also it is an excerpt from the doc teling it is possible.

When an existing Easy VPN deployment is based on Cisco IOS® Software and the customer wants to add DMVPN to the same hub. DMVPN  configuration can be added to the same hub without impacting the  existing Easy VPN setup. If the existing Easy VPN setup has clients  based on Cisco IOS Software routers, this setup can be converted into  DMVPN spokes if needed.

http://www.cisco.com/en/US/technologies/tk583/tk372/technologies_white_paper0900aecd80267995_ps6658_Products_White_Paper.html

You can also refer the following doc for dmvpn hub and ezvpn server on the same ios using profiles:

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00801eafcb.shtml

New Member

Re: DMVPN Question

Hi, thanks for your response. I looked at this document earlier and this does describe how to configure a DMVPN "HUB" as an Easy VPN server but not specifically a "SPOKE".

Which section are you referring to.

225
Views
0
Helpful
2
Replies
CreatePlease login to create content