Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DMVPN Routing Protocol

We currently use IPsec for our VPN setup. This includes a single core and approximately 75 (and growing) hubs.  I'm currently labbing a DMVPN environment to run some tests as part of a planned move. 

I know this question has been covered, but wanted to get some fresh perspective.  What routing protocols are you using for DMVPN and what are some of the issues you have faced? 

 

1 REPLY
Cisco Employee

Adam, Most of the setups

Adam, 

Most of the setups world wide will use EIGRP or BGP, very few specific cases use RIP passive, some OSPF or static routes.

For scaling and most internet-based setups we do recommend using BGP. It's well known, manageable, allowing load balancing and with a few tweaks perfect for large routing table and decent recovery times.

M.

38
Views
0
Helpful
1
Replies
CreatePlease to create content